coolent problem
#1
Senior Member
Thread Starter
Join Date: Aug 2004
Location: San Francisco
Posts: 588
Likes: 0
Received 0 Likes
on
0 Posts
coolent problem
catch can is filled up all the way to the top but "add coolent" light still comes on from time to time. i just change my water pump if it matters
#2
Rotary Freak
iTrader: (7)
The buzzer should sound with the 'add coolant' light.
Check the level at the rad cap, sometimes the system may not be able to draw from the overflow for various reasons.
If it is low then top up and get the system pressure tested to confirm no external leaks. If no leak is found do the dreaded o-ring test, detailed on RotaryResurection's website.
If the system was full when inspected then suspect the add coolant sensor at the centre top of the rad.
Check the level at the rad cap, sometimes the system may not be able to draw from the overflow for various reasons.
If it is low then top up and get the system pressure tested to confirm no external leaks. If no leak is found do the dreaded o-ring test, detailed on RotaryResurection's website.
If the system was full when inspected then suspect the add coolant sensor at the centre top of the rad.
#3
Carter 2.0
There is an air bubble trapped at the top of your radiator where the senser also resides. Look at the archives for a thread called "filling the radiator after rebuild" by Bob-the-normal
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM