Convertable top? Whats wrong here?
#1
Jack of All Trades
Thread Starter
iTrader: (2)
Join Date: Aug 2008
Location: Dallas Tx
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
Convertable top? Whats wrong here?
OK, call me an idiot. I cannot figure out how to get the targa off of the convertable top and uhm, yeah. I think I may be stupid.
Any instructions available???
Thanks
DallasFC1
Any instructions available???
Thanks
DallasFC1
#2
wankel head
Join Date: May 2004
Location: hamptonroads
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
interior hinge covers may be hiding the release...
open the top half way, push the button to fold the top, then push each orange release (located behind the hinges). make sure you hold the top level until both hinges are released. if you are good you can usually rest it on the headrests of the seats...
#5
Driving RX7's since 1979
iTrader: (43)
Join Date: Aug 2001
Location: So Cal where the OC/LA/SB counties meet
Posts: 6,096
Likes: 0
Received 8 Likes
on
8 Posts
Guys, he probably still has the stock covers over the orange release for the hook latch's.
There is a round single plastic coupler with a center pin that holds the cover in place. Push in the center pin, remove the coupler, and then GENTLY wiggle the cover free. You'll then see the orange lever previously spoken about. Same proceedure for both sides.
There is a round single plastic coupler with a center pin that holds the cover in place. Push in the center pin, remove the coupler, and then GENTLY wiggle the cover free. You'll then see the orange lever previously spoken about. Same proceedure for both sides.
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM