After putting on some new engine mounts and running the car for a few minutes, the buzzer came on that normally indicates redline, low oil, or low coolant. None of the lights on the cluster illuminate. and I know for a fact that I am not low on oil. Can this buzzer go off for low coolant even if the light is not lit? Also, is there a possibility that the vibration from the new mounts caused something to disconnect? If so, where can I check for loose connections?

Thanks- Jason

 

Do the lights work? Did you check the wires coming from the coolant and oil level sensors?

 

Yes, the lights do work (they turn on while starting or in the on position, and then go off once the car is started). I still have to check the wire for the oil, but I cant do it till tomorrow afternoon since I'd have to put it on a jack to see the oil pan.

 

Did you check the radiator level before posting?

If both fluid levels are okay, see the FSM Body Electrical System chapter for troubleshooting the warning system.

 

If the low coolant level sensor does not have a ground (water) then it will go off approx. 3 seconds after the car is started. You can ground the pig-tail but this is not recommended.