compression tube
#1
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
compression tube
Ive done a bit of searching and havne tcome up wiht much. Has anyone made theri own custom compression tube or modiffied the stock elbow to have the inlet point in the right direction/be the right diameter? Ive seen a couple of people who used the plastic N/A elbow, but i dont want to deal with plastic. Is there anything i should be aware of when designing the compression tube? I would prefer to make it myself as opposed to buying one. But if it will be cheaper to just buy it then i will do that
Thanks
Thanks
#3
sounds like hes talking about the tb elbow. Greddy makes one thats pretty nice.
http://www.rx7.com/store/rx7/GReddyElbowFC.html
http://www.rx7.com/store/rx7/GReddyElbowFC.html
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM