car runs great after clutch install and tranny replacement, BUT on cold start up it will go to about 2000k and then drop to 1500,tnen bounce from 1000 to 1500 till warm, if i jut drive it its fine, AND WHEN I PUT MY FOOT ON THE CLUTCH ALL BOUNCING STOPS AND GOES TO WHERE IT SHOULD BE 1500 SOLID OR WHEREVER IT SHOULD BE. I ALSO DID TPS SETTING ANT IT IT IS RIGHT ON THE MONEY.
CAR IS AN 88 NA, ANY HELP WOULD BE NICE, THANKS

 

pls help

 

car runs great

 

nobody can help?
do i gotta go ls1?
dont make me do it,i dont wanna,lol

 

Check TPS and BAC. Mine did the same thing after my clutch install. TPS was no good. Odd it happened to happen after the clutch job, though...

If you have to ask what those are, you haven't read the FAQ at the top of the page, or downloaded the FSM/Haynes manual.

 

i set the tps the ohm/ meter method, its right on and basically was, the bac hasent been checked yet,cars runs great, can u check codes without the oem tool?

 

????