Ok guys, i installed my SBC-id last week and ever since then my car WILL NOT idle cold. I turns over, revs up to 2.5-3 for about 3 seconds then dies out. I've check all the vacuum hoses and the AFM connection and can't think of what else it might be. It was been cold here for a little bit and it idled fine before the SBC install. Any ideas?

Thanks

Aaron

 

^^

 

You really shouldn't even relate this to 2nd Gens anymore. Just because it's in an FC doesn't mean that we can help. You're now dealing with a V8.

Check your fuel, ignition, and timing again. Also, try this in the General Automotive section.

From now on, your FC isn't 100% FC. It's FC from the Firewall back, not including the transmission. If you have a suspension problem, you're best off here. If you have a problem with the engine or the transmissionl you'll probably get better help in the GA section.

I'm not trying to be an ***, just trying to get you the best help this forum can provide.

 

Why is my rotary engine now a V8???? ****, if i knew my boost controller would give my car pistons and valves I would have never installed it.........

Aaron

 

hahaha

 

be too much of a pain to remove it to make sure thats the problem then you could narrow it down?

 

Wow, now I feel like a dumbshit!

I was wondering why you had recent rotary posts then all of a sudden were mentioning an SBC (which with normal car-guys translates to Small Block Chevy)

 

Its all good man... i prly should have stated Blitz SBC-id.... anyways... she still being a little bitch

Aaron