code 3 how to fix?
03-14-03, 03:31 PM
#2
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
The G signal is the rotor position signal. Ring out the two coils on the cas from the ECU plug. See the fsm for pin numbers. Probably a loose connection at the cas or ECU. Or someone has been fiddle frickin with the inside of the cas.
03-14-03, 08:12 PM
#3
Lives on the Forum
It sounds to be a notorious problem for Kouki cars.  I helped another member "fix" this problem with a CAS swap, but it turned out to be a bad connection.  I'm working on a Kouki vert right now that spits out that same code.
Pull connector and try and see if you can clean all contacts.  Push connectors together HARD to make sure proper contact.  The mag sensors rarely fail themselves.
-Ted
Pull connector and try and see if you can clean all contacts.  Push connectors together HARD to make sure proper contact.  The mag sensors rarely fail themselves.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post