I am looking to purchase a set of cobra wheels, and they are 17x9 front and
17x10.5 rear. Unfortunatelly the seller does not know the offset of this wheels.

Now the question is ...what's the ideal offset for these size of wheels to fit an fc?? and may be also suggestion of the rubbers size?? and also to rock a 9" front and 10.5" rear on an fc, will I require a widebody kit??

thanks in advance

 

find the offset. You will get different opinions on the offset on this forum since some will tell you to run conservative, others will say go extreme. With those 17x10.5, a fender roll/pull will be necessary. What type of suspension do you have?

 

i am running hks hypermax coilover..(with camber plate front and mazdatrix adjustable rear camber bar)

I guess..i will called ford dealer and find out the offset for this wheels...

 

dunno if ford will have the offset for aftermarket lol, was 17x10.5 a factory size?

hmm
http://cgi.ebay.com/ebaymotors/Deep-...Q5fAccessories

http://cgi.ebay.com/ebaymotors/SVT-0...Q5fAccessories

good sizes imo go for it

 

yea..actually its factory size (or atleast it looks like it to me).

link below vvv

http://toronto.kijiji.ca/c-cars-vehi...QAdIdZ95157605

 

have you seen this thread?
https://www.rx7club.com/2nd-generation-non-technical-pictures-198/cheap-dish-wheels-778500/

some good looking mustang wheels, no one here has attempted to rock em from what i can tell.. but they look great on the 240s on the last page