Rx7Nub

ok, well, my clutch is shot, i went to drive car today, and i go to push clutch in, and nothing, no pressure at all, the only gear I can put it in, is 2nd, and thats a bitch, so what do you guys recomend for a new clutch, money is a problem... it's gotta be a decent clutch, that is cheap, please help
-Mark

jeremy

iTrader: (1)

a bought a clutchmasters for my na that was cheap and had the pressure plate, to bearing, and pilot bearing. i think it was like $150ish. it hasn't been that bad of a clutch.

slvr7

iTrader: (1)

I don't think you're looking at a clutch problem per se, but more likely a problem with the hydraulics. Check the clutch master cylinder, the line to the slave cylinder, and the slave for evidence of leaking fluid.

Curtis
'86 gxl autox'r

ra ra rotory

yeah....if your 'clutch' was shot, it would still have pressure, unless the pp broke or something, im not sure. I think it most likely is a leak in hydrolics

Rx7Nub

it may be something else, my immedieat reaction was just the clutch though, i will see if I can check the rest of it out...

13bpower

I would have to agree with everyone else. It dosent sound like the clutch has "gone out". If that were the case you would still be able to get it in gear, but the clutch just wouldn't "grab" the flywheel.

Rx7Nub

ahhh, ok, thanks alot

jeremy

iTrader: (1)

guess i should have read that more thoroughly huh.

dr0x

If there is no fluid the slave is shot, if there is fluid but no pressure its the master cylinder.

Rx7Nub

there is fluid, but no pressure, so how much is this going to cost me to fix??? coz right now im pretty broke..

Rx7Nub

bump - anyone know?

ra ra rotory

well according to drox, that measn the master is shot, which is alot cheaper than a clutch... put a new master on and bleed it and you should be fine. I think mazdatrix.com sells them, or one of those sites

ra ra rotory

http://www.mazdatrix.com/f-hydral.htm

GlenL

The same exact thing happened to me this weekend. I had to drive around clutchless until I could park it somewhere... and in Houston, that was a big PITA. I also need to replace a throwout bearing, so I'm going to get it done altogether now, along with a new Centerforce... although maybe I should've gotten an ACT now that I read more about the Centerforces.