Clutch Question
#1
Clutch Question
Alright Im doing the 5 speed swap and i was installing the clutch today, i put the clutch on then the preessure plate tightened the bolts, am i suppose to be able to turn the clutch inside by hand, because it is not moving, i was not sure if it is suppose to be like this or what can i do to solve the problem
Thanks
Dan
Thanks
Dan
#3
Rotary Enthusiast
Join Date: Mar 2001
Location: Victoria, BC, Canada
Posts: 959
Likes: 0
Received 0 Likes
on
0 Posts
Well it looks as though your not getting much action on this one
I guess that we are a little surprised that if you were able to install the clutch, that you don't know the answer to your own question.
The pressure plate is all that stops the clutch from spinning when the engine is running, but the short answer to your question is "no" you shouldn't be able to turn it!
With all of the rest in mind get a copy of the FSM and read about the procedure to be sure you have it in correctly.
I guess that we are a little surprised that if you were able to install the clutch, that you don't know the answer to your own question.
The pressure plate is all that stops the clutch from spinning when the engine is running, but the short answer to your question is "no" you shouldn't be able to turn it!
With all of the rest in mind get a copy of the FSM and read about the procedure to be sure you have it in correctly.
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM