2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

Clutch pedal going limp

Thread Tools
 
Search this Thread
 
Old 05-25-08, 01:07 PM
  #1  
Junior Member

Thread Starter
 
woode87's Avatar
 
Join Date: Jun 2005
Location: Willow Grove, PA
Posts: 46
Likes: 0
Received 0 Likes on 0 Posts
PA Clutch pedal going limp

I took my car across the flight line today and hit about 120mph and slowed down and when I put my clutch in, the pedal was practically dead.. I thought my clutch went out but after pumping it a few times it was back to normal. I tested it again, I went up to about 110 and slowed back down and the same thing happened. It doesn't do this under normal driving conditions (yet), what would be causing this? Is this a pre indicator of something happening?

There was no hard braking when I slowed down either, as a matter of fact I let it coast back down to about 80 before I even hit the brakes.. and I wasn't slipping the clutch. I have never had this happen (except when the clutch goes out in a car) and then go away like this.
Old 05-25-08, 01:52 PM
  #2  
The end of an era

iTrader: (4)
 
Andrew.'s Avatar
 
Join Date: Dec 2003
Location: Riverside, CA
Posts: 4,717
Received 6 Likes on 4 Posts
Check your clutch fluid level and clutch line (for leaks). If its fine, try bleeding the clutch and see if it continues. If it does continue, I'd suspect the slave.




All times are GMT -5. The time now is 05:42 AM.