ok so my clutch pedal was sticking to the floor. and i was able to get a little bit of pressure out of it , just enough to move the car. the clutch fluid was full ad wasnt leaking at all. so im thinking: clutch master cylinder needs to be replaced. so after finding one and installing it i notice that im not able to bleed the fluid out of the system at all. i take the bleeder valve off and pump the clutch pedal but no luck no fluid comes out.

anyone have any ideas?

 

sounds like a blockage in the line.

 

i recently had the same problum when installing a clutch. i pushed the clutch in when the line was not hooked up (stuped thing to do) and the piston in the master cylinder stuck between the rezivore and the outlet, so i used a bike pump and a old vacume line in the end of the pump, and put air pressure in the outlet to puch the piston back into position, then i could bleed it. you will know when the piston slides back because you will get bubles in the resivor. hope that helps.