Clutch Fan Removal???
#2
is The Whoopieschnootz
Join Date: Apr 2005
Location: Asheville NC
Posts: 700
Likes: 0
Received 0 Likes
on
0 Posts
4 bolts/nuts hold it to the water pump pulley. I remember it being annoying getting my hands where I could get wrenches on them, but not hard in any way.
Grab 2 I think 10mm wrenches, and set them coming out opposite sides on different bolts. Then "tighten" one while "loosening" another. In other words, pull both wrenches up, or push both down... whichever is less likely to skin your knuckles. Repeat until the torque is broken on all 4, and then thread them all out.
I figured I'd add in how to remove bolts on something that spins since you were already asking a fairly simple question. I hope I didn't offend.
Grab 2 I think 10mm wrenches, and set them coming out opposite sides on different bolts. Then "tighten" one while "loosening" another. In other words, pull both wrenches up, or push both down... whichever is less likely to skin your knuckles. Repeat until the torque is broken on all 4, and then thread them all out.
I figured I'd add in how to remove bolts on something that spins since you were already asking a fairly simple question. I hope I didn't offend.
#3
Full Member
Thread Starter
Join Date: Jul 2007
Location: Texas
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Thanks. I know its a simple question with what turns out to be a simple answer but... It was just that I saw 4 bolts on the back of the fan and there is the deal on the front with the springs, and I didnt know if either one of those would be the actual bolts to remove to get the fan off.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM