Check Connector Question
#1
Jpk3200
Thread Starter
Join Date: Oct 2006
Location: San Antonio, TX
Posts: 824
Likes: 0
Received 0 Likes
on
0 Posts
Check Connector Question
I am diagnosing a non-working Theft Deterrent System and noticed this in the wiring diagrams. I've pulled the hood switch and tested it and checks good according the the FSM in the Body Electrical Section. However, the security lamp stays on when I pop the hood instead of just flashing.
Could this be a culprit somehow?
Whether it is or isn't, where is this located, and what exactly does it do? This isn't one of those green pins is it? I couldn't find any more information on it being called a "Check Connector"
1990 TurboII
Could this be a culprit somehow?
Whether it is or isn't, where is this located, and what exactly does it do? This isn't one of those green pins is it? I couldn't find any more information on it being called a "Check Connector"
1990 TurboII
#2
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
The very next page in the FSM from the one in your post, shows the check connedtor on/near the CPU near the drivers left foot.
It has a reference designator, which is T-11. See the picture on the next page as suggested.
It has a reference designator, which is T-11. See the picture on the next page as suggested.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
befarrer
Microtech
3
08-22-15 05:52 PM