Ok Fri I finally got my unmodded throttle body off ebay to replace my modded one. I was sick of warming it up wasting gas before driving it. Well anyways I put it on and cant get it to idle well. Finally got it down to 2000 rpm but some throttle cable adjustment could help that.

Well the point of the story is since I got this new TB my car tends to stutter while driving at a low rpm. It just shakes and is getting quite annoying. The TPS has been adjusted to what it should be at, but it still stutters. IM CONFUSED. Someone help diagnose for me please.

 

Yo, doty. I'll help u at the school on friday, bring some tools. *** whooping time as arrived.

 

Bump

I cant figure the damn thing out. Doesnt really effect performance just annoying.

Come on Newton you shouldnt be thinking negative thoughts about getting your *** spanked, be a little more optimistic.

PS- Cant wait for the track on sunday!!!

 

um bump.... again

 

Vacuum leaks? Are the throttle plates sticky?

 

No obvious vacuum leaks found. I dont think the plates are sticky because I cleaned the TB good before I installed it.

 

I'm not going to race a disabled car Doty. It wouldn't be nice to make u look that bad. See if the throttle cord is catching on anything. Check all electrical connections.

 

Newton dont try to sqirm your way out of this, it doesnt effect performance at all. The cable isnt caught on anything, but Ill fiddle around with it again tonight.

PS- Look at my sig one more time Newton.

 

And what it still looks slow