car is still giving fits. idle fine can't drive it
#1
Rotary Enthusiast
Thread Starter
Join Date: Mar 2001
Location: Caldwell,ID
Posts: 968
Likes: 0
Received 0 Likes
on
0 Posts
car is still giving fits. idle fine can't drive it
as the title says I can let the car idle though that is a pain in itself. usually just to get it to idle right I have to sit there and start it over and over and over again cause it keeps dying.
once I get it idling though it idles nice and fine no miss problems or anything of the sort, but if I give it any gas at all it starts to run rough and the more gas I give it the rougher it runs till it finally dies. doesn't matter how quick or slow I move the throttle either
I've tried to disconnect the tps since I know it will run fine without one and it still does the same thing.
the highest rpm range I can get out of this thing is about 1000rpms then it fights me.
please help me out guys
once I get it idling though it idles nice and fine no miss problems or anything of the sort, but if I give it any gas at all it starts to run rough and the more gas I give it the rougher it runs till it finally dies. doesn't matter how quick or slow I move the throttle either
I've tried to disconnect the tps since I know it will run fine without one and it still does the same thing.
the highest rpm range I can get out of this thing is about 1000rpms then it fights me.
please help me out guys
#2
Lives on the Forum
AFM?
Read it out at the ECU (search), as the throttle is pressed (and the intake air opens the door farther), the voltage should go up. If it's not, that's your prob...
Read it out at the ECU (search), as the throttle is pressed (and the intake air opens the door farther), the voltage should go up. If it's not, that's your prob...
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
82streetracer
Haltech Forum
11
03-11-19 05:34 PM