2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Car just f*ckin quits

Thread Tools
 
Search this Thread
 
Old Mar 12, 2003 | 09:34 PM
  #1  
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Mar 2003
Posts: 228
Likes: 0
From: Florida
Car just f*ckin quits

I just got a 88 gxl. It sat for quite a while, but i got most of the problems fixed like the tps and the fuel system. And now everything has been fine for about a month, but quite a few times the engine just shuts off.(litterally just f*ckin stares back at me like its supposed to do sumthin) There no indication of anything, no noises, no drivablity problems, all the gauges are fine. it usually occures the most when i turn the ac on, but it does it when its off as well. It alwayz start back up on the 2nd try but never the first. and then its fine again, it will rev hard and drive good like nuthin ever happened. Can anybody help????? thanks


ps it idles low, here and there, but not all the time
Reply
Old Mar 12, 2003 | 09:56 PM
  #2  
BlackRx7's Avatar
Daily Domestic Killer
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 2,425
Likes: 0
From: San Antonio, Tx, USA
adjust your Idle...how did you adjust your tps? you idle should atleast be 750...but if you have any mods you should bump it up allittle....try adjusting the BAC..you can get info on ajusting it with the FSM found at www.fc3s.org
Reply
Old Mar 12, 2003 | 09:59 PM
  #3  
Rxmfn7's Avatar
Do a barrel roll!
Tenured Member 20 Years
iTrader: (4)
 
Joined: Oct 2001
Posts: 7,529
Likes: 2
From: Lower Burrell, PA
Yea, sounds like a BAC problem if it does it when you turn the A/C on.
Reply
Old Mar 12, 2003 | 10:46 PM
  #4  
silverrotor's Avatar
Moderator
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Mar 2002
Posts: 7,592
Likes: 5
From: Toronto, Corporate Canada
Verify If the actual By Pass Air Control Valve Is working by removing It. From there, apply voltage from the Battery with 2 wires you may have kicking around. Connect and reconnect and confirm you see the valve actuating In conjunction with a clicking you should here. While you are at It, clean It with the above directions buy giving It a shot of WD-40 and persistantly apply voltage to work It In. After that, blow out as much as you can than wipe dry.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
cristoDathird
Introduce yourself
28
May 30, 2019 08:47 PM
autoxer
3rd Generation Specific (1993-2002)
21
May 22, 2019 04:07 PM
Casual_John
Canadian Forum
3
Aug 22, 2015 11:59 PM
armans
3rd Generation Specific (1993-2002)
5
Aug 15, 2015 09:08 PM




All times are GMT -5. The time now is 12:38 AM.