Well guys, we cant get spark AT all. We just installed a microtech standalone, and got everything working good. Lights all on, voltage there. But no spark. Yes we checked the engine fuses. We are getting fuel, because it was leaking out of the regulator a little because it wasnt tight, but alteast we know fuel is there. It wont do anything. We have tried directly wiring the coilpacks but nothing. Any help? Yes ive searched. Anyone in the area willing to give a hand thats done a standalone?

 

make sure your CAS is wired correctly, i had the same problem my first time.the wire colors change after the plug.if its correct then you can pull the cas and rotate it by hand and you should hear injectors clickin away, with key on. check wiring to coils too.

 

We have tried..cas is correct..checked it. Anyone else..we are about to take it to a local shop and see what they say.

 

Any other suggestions or help?

 

Hey, If you figure anything out, let me know. I just installed the emange ultimate and No spark for me either!!

 

Isn't there a Microtech Forum on this site? Don't they ever answer questions?

It's hard to figure out why a Microtech will/will not work if a person does not have the wiring diagrams for it and the install instructions. Just FYI