calling out to s4 t2's low impedence secondaries. where do u put your resistors?
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jul 2003
Location: milpitas, CA
Posts: 1,133
Likes: 0
Received 0 Likes
on
0 Posts
calling out to s4 t2's low impedence secondaries. where do u put your resistors?
caling out to s4 t2's with stock high impedence secondary injectors that has aftermarket low impedence secondaries. where do u put your resistors? i was told to put it near the ecu to keep away from the heat. but i dont have a fsm so i don tknow the ecu pinout. anyone can help? how about in the engine wiring harness? pics for both?
thanks
eric.
thanks
eric.
#2
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
I agree the resistors should be located at the ECU.
Front primary: pin 3E, light green wire
Rear primary: pin 3C, light green wire with a black stripe
Front secondary: pin 3H, light green wire with a white stripe
Rear secondary: pin 3F, light green wire with a red stripe
All of this info is in the Factory Service Manual (FSM). Go to www.iluvmyrx7.com/2nd_gen_manuals.htm and download it in PDF format for free.
Front primary: pin 3E, light green wire
Rear primary: pin 3C, light green wire with a black stripe
Front secondary: pin 3H, light green wire with a white stripe
Rear secondary: pin 3F, light green wire with a red stripe
All of this info is in the Factory Service Manual (FSM). Go to www.iluvmyrx7.com/2nd_gen_manuals.htm and download it in PDF format for free.
Last edited by NZConvertible; 10-03-04 at 04:52 AM.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM