Bypassin the amp...i hope
02-04-02, 08:02 PM
#1
.....shhh hes coming.....
Thread Starter
Join Date: Dec 2001
Location: Sacramento, CA
Posts: 151
Likes: 0
Received 0 Likes
on
0 Posts
Bypassin the amp...i hope
i have an 86 na and im tryin to bypass the amp. i took out the rear speaker and that bucket thing. what do i do now???
02-04-02, 09:46 PM
#2
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
Are you replacing the speakers? If so just run new wire, the stock stuff is too skinny. If not, why are you bypassing the amp? You'll get bugger all out of it without it.
02-04-02, 10:19 PM
#3
Full Member
Join Date: Nov 2001
Location: Ohio
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
If you want to bypass the front passenger side speaker amp:
1) Remove speaker enclosure
2) Disconnect cnnector from speaker enclosure
3) Cut and connect the following wires:
Light Green with Red Stripe to Blue with Yellow Stripe
Light Green with Black Stripe to Blue with Red Stripe
Light Green to Large terminal (+) of Right Spkr
Light Green with Yellow Stripe to Small terminal (-) of Right Spkr
This will successfully bypass the amplifier so you can use the factory speaker wiring running from the speaker back to the corresponding speaker wiring at the head unit.
1) Remove speaker enclosure
2) Disconnect cnnector from speaker enclosure
3) Cut and connect the following wires:
Light Green with Red Stripe to Blue with Yellow Stripe
Light Green with Black Stripe to Blue with Red Stripe
Light Green to Large terminal (+) of Right Spkr
Light Green with Yellow Stripe to Small terminal (-) of Right Spkr
This will successfully bypass the amplifier so you can use the factory speaker wiring running from the speaker back to the corresponding speaker wiring at the head unit.
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM