Bucking Badly...
#1
Rotary Enthusiast
Thread Starter
Join Date: Jul 2004
Location: Lubbock,Tx
Posts: 881
Likes: 0
Received 0 Likes
on
0 Posts
Bucking Badly...
Well,
as some of you know I have been working on getting an 86 NA back on the road. Well all seems to be going well. I have the 3500rpm hesitation which I have to hunt down that problem as well. Idle also runs at around 1k rpm.
Those are not my largest problem though. Last night it was idleing fine and even running fine when test drove. Well I noticed the speedo cable wasn't hooked up to the back of the gauge. I hooked it up and the speedo works but now before I can even get past 2k rpms in first gear the car begins to buck badly.
Could this just be a freak accident cause I don't see a speedo cable doing that. Maybe a low voltage problem?
Mike
as some of you know I have been working on getting an 86 NA back on the road. Well all seems to be going well. I have the 3500rpm hesitation which I have to hunt down that problem as well. Idle also runs at around 1k rpm.
Those are not my largest problem though. Last night it was idleing fine and even running fine when test drove. Well I noticed the speedo cable wasn't hooked up to the back of the gauge. I hooked it up and the speedo works but now before I can even get past 2k rpms in first gear the car begins to buck badly.
Could this just be a freak accident cause I don't see a speedo cable doing that. Maybe a low voltage problem?
Mike
Thread
Thread Starter
Forum
Replies
Last Post
NLPerformance
1st Generation Specific (1979-1985)
26
10-10-15 08:59 PM