87' turbo II
full rebuild
blitz sbc-id boost controller
ported wg
3 inch al lthe way bak
rtek 1.7
720 sec.
walbro fuel pump
few other minor mods.


So i just picked up my car from getting the motor rebuilt at the rx7store./shop . after leaving ive noticed my boost controller and boost guage both stay on 5 psi as i drive... even if im off the gas somtimes it would drop down to 0psi. also instead of hearing a nice swhoooosh noise coming from my bov like usual i was hearing a chatter/turkey call kind of noise. No i was not boosting either.

what could the problem be . wastegate? electrical? bov?

 

1st picture- where does this tube go to??
2nd picture- doesnt this look weird ??? before it went to shop for rebuild the tubes werent setup like this im real confused as to how it is setup

 

can people post close ups of there engine bay mainly the left side of it so i can figure out/ make sure all the tubing is correct

 

You need to take it back to them, a lot of things there don't look right. Not to mention..it appears that one vacuum line isn't even connected to anything ????


This was rx7store.net??

 

Yep .

 

if i could find sum good pictures of peoples engine bays it would help me greatlyyy

 

Figured out was wrong they had the tube fro mthe map sensor going to where the tube to the bov / boost controller should be going so i swapped the 2 and whaaala!