boost problem...any ideas?
#1
boost problem...any ideas?
First a little detail of my setup...
Rebuild Jspec motor with street port
660cc secondary injectors
walbro pump
g-force re-mapped ecu
K&N filer on stock TID
bonez cat
Apexi N1 single
Normally it makes about 12psi peak and falls off a bit towards redline, but recently boost response is reduced, and peak boost is lower. I can get 10psi in 4th gear but in first-third it doesn't want to get past about 8 psi and builds pretty slowly. Any ideas?
Rebuild Jspec motor with street port
660cc secondary injectors
walbro pump
g-force re-mapped ecu
K&N filer on stock TID
bonez cat
Apexi N1 single
Normally it makes about 12psi peak and falls off a bit towards redline, but recently boost response is reduced, and peak boost is lower. I can get 10psi in 4th gear but in first-third it doesn't want to get past about 8 psi and builds pretty slowly. Any ideas?
#3
oki man I got the same problem as well
you could have one of 3 problems
either sometihng is opening your wastegate
or u got a clogged cat or any exhaust system part
or finally the one u dont want to hear is the turbo itself is getting weak and cant produce good spool (that was my problem by the way)
you could have one of 3 problems
either sometihng is opening your wastegate
or u got a clogged cat or any exhaust system part
or finally the one u dont want to hear is the turbo itself is getting weak and cant produce good spool (that was my problem by the way)
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM