Blow-through carbs on a turbo engine...I want some info
02-26-03, 10:12 PM
#26
Senior Member
Join Date: Jan 2003
Location: Tampa, Fl
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
02-26-03, 10:52 PM
#27
Amish Gangsta
Join Date: Dec 2001
Location: Woodland Hills, CA
Posts: 432
Likes: 0
Received 0 Likes
on
0 Posts
Robert @ Rotary Shack has a lot of knowledge with turbos and blow-thru set-ups.
03-30-03, 01:37 PM
#28
Senior Member
Join Date: Apr 2002
Location: in my car
Posts: 318
Likes: 0
Received 0 Likes
on
0 Posts
I am running a Jay-Tech manifold with a Holley 650 and it works great. I also have a stand alone injector system in the hard piping for high end rpm's and boost. All I know is that this setup is easier and cheaper than EFI....Hands down! The only problem that I have run into is getting a carb that will hod up to my 30 lbs. of boost. Its going to cost me $550 to get mine sealed so if anyone knows of a cheaper place do tell.
Thread
Thread Starter
Forum
Replies
Last Post
thecody59
1st Generation Specific (1979-1985)
40
08-23-15 06:41 PM
Turblown
Vendor Classifieds
0
08-18-15 10:01 PM
