2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

before I start the car I should?

Thread Tools
 
Search this Thread
 
Old Mar 31, 2010 | 03:54 PM
  #1  
Zelgadis2113's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Dec 2006
Posts: 9
Likes: 0
From: hawaii
before I start the car I should?

well to make a long story short. I=Marines. Sold to friend. Friend=broke=sitting for years now. I would like to start working on the car just because he's not doing anything with it so what do i need to know before I try and start the car after a few years of down time. I'm guessing changing the oil, anything else? I was going to check the spark plugs, vacuum hoses, and change the oil.
Reply
Old Mar 31, 2010 | 04:29 PM
  #2  
mikemclain11's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Aug 2006
Posts: 175
Likes: 0
From: indiana
would definately try turning if over by hand a little to make sure the seals arent sticking then dump some atf or mmo in each spark plug hole and turn over 1 complete turn and repeat 3 times for all 3 rotor faces just to lube up the seals, sounds like you got the just with spark plugs, vacuum hoses, and oil.
Reply
Old Mar 31, 2010 | 04:56 PM
  #3  
MMoore4545's Avatar
Senior Member
Tenured Member 10 Years
iTrader: (7)
 
Joined: Dec 2008
Posts: 603
Likes: 0
From: WNC
There is no reason to Put ATF in the Rotary.
Ever.
Aaron Cake does a great job explaining it's effects on his webpage.
http://www.aaroncake.net/rx-7/atftrick.htm

Use Regular 4cycle or 2cycle oil. if needed at all
generally used for badly flooded, or new motors to add a little compression to get it started..


you should be able to turn it by hand, unless you have a full compliment of accessory belts, then it may be slightly difficult

replace your fluids
replace filters
do a regular 60k tune up.
and you should be ready to roll
Reply
Old Mar 31, 2010 | 05:35 PM
  #4  
Go48's Avatar
Rotary Freak
Tenured Member 15 Years
iTrader: (7)
 
Joined: Feb 2005
Posts: 1,608
Likes: 3
From: Mont Alto, PA
Especially replace the fuel and possibly the filters as well. There is an external filter and a "sock" in the tank attached to the fuel pump. Get the factory shop manuals at the link below for info on how to.

http://foxed.ca/foxed/index.php?page=rx7manual
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Kyo
2nd Generation Specific (1986-1992)
6
Apr 13, 2019 09:24 AM
smikels
2nd Generation Specific (1986-1992)
3
Aug 18, 2015 01:26 PM
torky007
3rd Generation Specific (1993-2002)
7
Aug 17, 2015 05:14 PM




All times are GMT -5. The time now is 08:30 AM.