apex seals
#1
Junior Member
Thread Starter
Join Date: Jan 2009
Location: Paramount
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
apex seals
hey im half way done wit my rebuild and was wondering if the apex seals, side seals and springs, etc...that were originally on a 13b turbo can fit and work with no problem on the rotors of a 13b non turbo? thanks alot
#3
rotorhead
iTrader: (3)
I'd also recommend you check the side seal clearance. if they are much looser than .003" - .004" I would consider getting new side seals. My motor had side seal clearance at about .005" (max allowable is about .006") and it would get blowby under cold start, burning oil. it was fine when it warmed up though.
Thread
Thread Starter
Forum
Replies
Last Post
Snook
Single Turbo RX-7's
18
10-08-15 10:09 PM