anyone have vacume diagram for 87 NA
#1
Newbie
Thread Starter
Join Date: Jul 2002
Location: Washington
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
anyone have vacume diagram for 87 NA
Have just done an engine replacement, but have one vacume hose thats not going anywhere and no other open lines. Need to see if anyone has a vacume diagram and if not ill need to run to the junkyard and start ripping one apart to see where i missed. Also having trouble with flooding when trying to start(started for 15 seconds, flooded, removed fuse turned over, wont restart). Should i try using the ATF method to get compression for my first start on fresh rebuild? Thanks for any info or suggestions on getting this thing running.
#2
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
Do yourself a favour; go to www.fc3s.org and under the How-tos section you’ll find the Factory Service Manual to download for free. Just download the chapter(s) as you need them. The EFI chapter (4A) has the vacuum diagrams you need.
The FSM is absolutely invaluable for learning how the car works and troubleshooting problems. Plus it’s much quicker to look it up in the FSM than ask here and wait for a response!
The flodding problem is often related to dirty injectors. Have you had them professionally cleaned? If not, do it.
The FSM is absolutely invaluable for learning how the car works and troubleshooting problems. Plus it’s much quicker to look it up in the FSM than ask here and wait for a response!
The flodding problem is often related to dirty injectors. Have you had them professionally cleaned? If not, do it.
Thread
Thread Starter
Forum
Replies
Last Post
FbFuninthesun
New Member RX-7 Technical
3
10-06-15 08:03 AM
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM