Anybody using Zerex Asian coolant/antifreeze?
10-21-19, 01:20 PM
#1
Information Regurgitator
Thread Starter
Anybody using Zerex Asian coolant/antifreeze?
I know some people use the Mazda FL22 but is anyone using this Zerex Asian Blue?
https://www.valvoline.com/our-produc...freeze-coolant
Since my wife's Mazda 3 calls for FL22 I was gonna use this and switch my Rx7 over to it as well.
It's supposed to meet Mazda's spec's according to information on some other website's/forums. I've always used Prestone but just last week learned that it's a Dexclone. So I've basically been running Dexcool for the 60,000 miles since my rebuild. I'm kinda pissed but I guess it's my fault for not researching what changed when it became the extended life/ all makes all models formulation. I wrongly went by orange is bad(Dexcool). Green is ok. Apparently dye color don't mean s**t. I guess on the bright side my last engine's failure had nothing to do with coolant. 3pc. Apex seal tried to roll out of the groove around 143,xxx miles.
https://www.valvoline.com/our-produc...freeze-coolant
Since my wife's Mazda 3 calls for FL22 I was gonna use this and switch my Rx7 over to it as well.
It's supposed to meet Mazda's spec's according to information on some other website's/forums. I've always used Prestone but just last week learned that it's a Dexclone. So I've basically been running Dexcool for the 60,000 miles since my rebuild. I'm kinda pissed but I guess it's my fault for not researching what changed when it became the extended life/ all makes all models formulation. I wrongly went by orange is bad(Dexcool). Green is ok. Apparently dye color don't mean s**t. I guess on the bright side my last engine's failure had nothing to do with coolant. 3pc. Apex seal tried to roll out of the groove around 143,xxx miles.
Thread
Thread Starter
Forum
Replies
Last Post