Any suggestions
#1
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Tampa, Fl
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
Any suggestions
My car is hesitating between 4800rpm and 6000. It kinda bucks a little like braaaaaa, brap, brap, braaaa, brap, braaaaaaaa then clears out after 6k, pulling nicely if i may add. It started doing it a few weeks ago, then i replaced the rear coil and it drove BEAUTIFULLY. Then the next day i added a CAI, and i got the same hesitation. I was thinking it might be my CAI but i rechecked it and tightened everything to make sure there were no leaks. I didnt think grounding would fix it like the 3800 hesitation. Has anyone else ever experienced something like this? Any suggestions?
#2
Senior Member
Join Date: Apr 2003
Location: New Idaho
Posts: 523
Likes: 0
Received 0 Likes
on
0 Posts
Yeah,
maybe you bumped your AFM plug loose. And it needs to be cleaned and or stuck back together solidly.
After all you add a cold air intake. So that could be it.
Also you might have knocked the hose loose that goes from the CAI part of the AFM to the airpump too. But then again I don't know what CAI you got. MY K&N hose to air pump is blocked off.
Good luck.
maybe you bumped your AFM plug loose. And it needs to be cleaned and or stuck back together solidly.
After all you add a cold air intake. So that could be it.
Also you might have knocked the hose loose that goes from the CAI part of the AFM to the airpump too. But then again I don't know what CAI you got. MY K&N hose to air pump is blocked off.
Good luck.
#4
Senior Member
Thread Starter
Join Date: Jan 2003
Location: Tampa, Fl
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
Hopefully, my new E-Manage and an MSD 6AL will clear it up. Any comments, hints, tips or suggestions would be great though. Especially if you have experienced something like this. Its only between 5 and 6k rpm, at full throttle. Before and after its fine.
Thread
Thread Starter
Forum
Replies
Last Post