Any help would be appreciated...
#1
Junior Member
Thread Starter
Join Date: May 2005
Location: Delaware
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Any help would be appreciated...
I searched a few posts an dsaw a few starting issues but none that matched mine. I noticed when it started to get colder once in awhile when I pressed on the clutch to start the car nothing would happen. As it got colder it got worse. So last night I go to work and it won't start since it was really cold. But then after about maybe 10 minutes she just fired right up. When I went to leave work this morning nothing, and she is still there. Won't start at all. I thought that maybe it miight be the neutral switch(which I played around with a bit). I'm kinda hoping someone has had already taken care of this problem and might know exactly what it is. There is no problem with the battery at all, basically when you turn the key you hear nothing. Not sure if maybe the starter crapped out or maybe the ignition switch is bad. Any help you guys could give me would be greatly appreciated!!! Oh and its an 87 SE.
Trending Topics
#8
Rotary Enthusiast
ok i had the exact same problem it turned out to be a switch on my clutch pedal up underneath the dash i had to desolder the switch from the connector and then take the 2 wires on the connector and solder those together and reconnect the connector wit the one under you dash, and when i did this my car has been running fine ever since.
#9
Junior Member
Thread Starter
Join Date: May 2005
Location: Delaware
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
I'm hoping thats all the problem is rx7b13!! I need it to be something cheap and easy, haha. As soon as my friends calls me back I'm going to go try again. Thanx for the help guys!!!
Thread
Thread Starter
Forum
Replies
Last Post
fastrx7man
3rd Generation Specific (1993-2002)
33
09-02-15 09:42 PM
1adzam
2nd Generation Specific (1986-1992)
23
09-02-03 09:08 PM