well after the motor swap the car started fine on 1 year old gas still in the car and old *** plugs. Then after the safc install it doesnt start. It started right after but then I flooded it. I had not flooded it until the safc install. I put new gas and plugs and it will fire a little but not run. Anyone have this problem. How do I jumper the thermoswitch to think the car is warm so it dumps less fuel? What pin and voltage/resistance?

 

Have you rechecked your SAFC settings? Sounds like your AFM settings are off.

 

I second that.

 

my sensors check good and i can monitor the afm %, also i have previously ran it without the afm plugged in with the pump switched on. I have the sensor set 4-4 which is flap. Sound ok?

 

Well, if it DIDNT flood before the SAFC, and it FLOODS after the SAFC, either your settings or corrections are messed up, or the AFM settings are wrong.

 

ya it is pretty obvious once i type it but it is never that simple when im working on it. Im just gonna pull the safc make sure thats the problem then go from there. Thanks

 

set your sesor type to flap 5in 5out
and turn all your settings to 0
and make sure your motor is at 4cyl with the arrow up