Another mod to increase stock wastegate effectiveness?
#1
Learned alot | Alot to go
Thread Starter
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
Another mod to increase S5 stock wastegate effectiveness?
Ill have pictures later to describe a little more what im talking about, But
I have been porting the wastegate on an S5 Stock turbo when i noticed that the wastegate flapper has a small wear spot where it has been pressing against the turbine/wastegate cover thing, and there is a matching wear spot on the cover
Has anyone ever tried reliving this area in the flapper and/or the cover to allow the flapper to swing open more? I would try it on this one, however it was just sold.
-Jacob
I have been porting the wastegate on an S5 Stock turbo when i noticed that the wastegate flapper has a small wear spot where it has been pressing against the turbine/wastegate cover thing, and there is a matching wear spot on the cover
Has anyone ever tried reliving this area in the flapper and/or the cover to allow the flapper to swing open more? I would try it on this one, however it was just sold.
-Jacob
Last edited by CrackHeadMel; 02-19-04 at 06:10 PM.
#3
Lives on the Forum
#4
Hot Dicken's Cider
iTrader: (2)
Join Date: May 2003
Location: Marion, Ohio
Posts: 1,428
Likes: 0
Received 0 Likes
on
0 Posts
I ground down the top of my flapper door, and ground the flapper door arm down so exhaust would flow better around it. i also ground down the spot where the flapper door hits the cover. Id say the door opens at least 1/4" more than stock. Havent got my car spoolin again yet, so i dont know how well it works.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM