Another car wont start ..
09-29-12, 08:12 PM
#1
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jan 2003
Location: NJ
Posts: 1,039
Likes: 0
Received 0 Likes
on
0 Posts
Another car wont start ..
once again i searched and havent found this answer . but i cant get my 91 t2 to start. . I put new plugs in..
-put oil in the leading..
-charged the battery .
-did all the flooding procedures..
-checked for spark
-checked all fuses
-checked fuel pump grounds.
the only thing that i have seem to notice is when i first start to crack it the rpm goes up to 15-1800 rpms( car is halfbridge).. then after awhile it goes to 2-270 rpms if that .. im stuck any ideas.. i am thinking the cas maybe?
-put oil in the leading..
-charged the battery .
-did all the flooding procedures..
-checked for spark
-checked all fuses
-checked fuel pump grounds.
the only thing that i have seem to notice is when i first start to crack it the rpm goes up to 15-1800 rpms( car is halfbridge).. then after awhile it goes to 2-270 rpms if that .. im stuck any ideas.. i am thinking the cas maybe?
09-29-12, 09:29 PM
#2
They live We sleep
iTrader: (1)
Join Date: Feb 2009
Location: Dot Island
Posts: 919
Likes: 0
Received 0 Likes
on
0 Posts
once again i searched and havent found this answer . but i cant get my 91 t2 to start. . I put new plugs in..
-put oil in the leading..
-charged the battery .
-did all the flooding procedures..
-checked for spark
-checked all fuses
-checked fuel pump grounds.
the only thing that i have seem to notice is when i first start to crack it the rpm goes up to 15-1800 rpms( car is halfbridge).. then after awhile it goes to 2-270 rpms if that .. im stuck any ideas.. i am thinking the cas maybe?
-put oil in the leading..
-charged the battery .
-did all the flooding procedures..
-checked for spark
-checked all fuses
-checked fuel pump grounds.
the only thing that i have seem to notice is when i first start to crack it the rpm goes up to 15-1800 rpms( car is halfbridge).. then after awhile it goes to 2-270 rpms if that .. im stuck any ideas.. i am thinking the cas maybe?
09-30-12, 07:53 PM
#3
Rotary Enthusiast
Thread Starter
iTrader: (1)
Join Date: Jan 2003
Location: NJ
Posts: 1,039
Likes: 0
Received 0 Likes
on
0 Posts
ok i got it running ..but when u give it gas / blurp the throttle it dies out.. if you hold the gas pedal it will stall it .. I went in reverse an dlet the clutch out it died but fuel pressure stayed consistent. sat for a week bad gas with 2 cycle or should i try to let it run and clean itself out
Thread
Thread Starter
Forum
Replies
Last Post