All JSpec RX7's had 4.3 ratio Diffs??
Thread Starter
Joined: Aug 2001
Posts: 6,096
Likes: 9
From: So Cal where the OC/LA/SB counties meet
All JSpec RX7's had 4.3 ratio Diffs??
I remember reading this in another thread, and wanted to confirm.
Yes? No?
Or, was this just true for the limited run Infinity series?
Yes? No?
Or, was this just true for the limited run Infinity series?
Last edited by HOZZMANRX7; Oct 26, 2002 at 01:01 AM.
infini guru
Joined: Nov 2001
Posts: 1,183
Likes: 0
From: Sunnyvale, CA
Originally posted by HOZZMANRX7
I remember reading this in another thread, and wanted to confirm.
Yes? No?
Or, was this just true for the limited run Infinity series?
I remember reading this in another thread, and wanted to confirm.
Yes? No?
Or, was this just true for the limited run Infinity series?
Steve "Oooooooh, cheap shot!"
Last edited by MtnRacer; Oct 26, 2002 at 02:52 AM.
Former Moderator. RIP Icemark.
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
I have also heard that all the manual tranny JDM FCs were 4.3, but have only founf one written place that describes that. I typically don't call it fact until I get two.
Trending Topics
Thread Starter
Joined: Aug 2001
Posts: 6,096
Likes: 9
From: So Cal where the OC/LA/SB counties meet
Ok, then.......
Who has the Japan connection that will jack up the rear, turn the rear diff. half shaft one full turn and report back if the drive shaft turned 4.1 or 4.3 turns.
Thread
Thread Starter
Forum
Replies
Last Post
whizzybang
Naturally Aspirated Performance Forum
21
Feb 10, 2017 12:08 PM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM
