Alarm installation, need wiring
#1
Rotary Freak
Thread Starter
Join Date: Aug 2001
Location: Ottawa, Ontario
Posts: 2,788
Likes: 0
Received 0 Likes
on
0 Posts
Alarm installation, need wiring
Hey guys, i need the wiring for an 89 turbo II to install an alarm/remote starter. I will probably remove the stock alarm in order to install this one.
Thanks
-Ross
Thanks
-Ross
#2
Despise Enmity
Join Date: May 2001
Location: Richmond, VA
Posts: 2,420
Likes: 0
Received 0 Likes
on
0 Posts
#3
Rotary Freak
Thread Starter
Join Date: Aug 2001
Location: Ottawa, Ontario
Posts: 2,788
Likes: 0
Received 0 Likes
on
0 Posts
actually, my main concern was for the alarm to check if the car is in gear before using the autostart feature. Is there a built-in neutral position switch??
Thanks
-Ross
Thanks
-Ross
#5
Former Moderator. RIP Icemark.
The neutral start wire is Green/Black and can be found at the ECU or the harness coming in on the fire wall (but its easier to get to at the ECU). It is found in the first plug, pin G.
If you are useing a DEI remote start, you can use that wire for the black/white neutral safety wire as there is ground on the Grn/Blk when the car is in neutral.
BTW: you may wish to search through either this forum or the exterior/interior/audio section, as I know I have posted the colors for alarms and remote starts more than once.
If you are useing a DEI remote start, you can use that wire for the black/white neutral safety wire as there is ground on the Grn/Blk when the car is in neutral.
BTW: you may wish to search through either this forum or the exterior/interior/audio section, as I know I have posted the colors for alarms and remote starts more than once.
Last edited by Icemark; 04-30-03 at 10:37 PM.