Air pump removal question
#1
Full Member
Thread Starter
Join Date: Jan 2004
Location: Raleigh, NC
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Air pump removal question
I just installed a new water pump yesterday and am putting new belts on today to finish her up.
I also decided that I want to take out my ACV and air pump while I have stuff disassembled. I only need to order a few block off plates.
-So my question is can I go ahead and leave the air pump off while the ACV remains in tact until I order my block off plates? Will that cause any problems?
Its an S4 NA.
Thanks
I also decided that I want to take out my ACV and air pump while I have stuff disassembled. I only need to order a few block off plates.
-So my question is can I go ahead and leave the air pump off while the ACV remains in tact until I order my block off plates? Will that cause any problems?
Its an S4 NA.
Thanks
#2
Full Member
Thread Starter
Join Date: Jan 2004
Location: Raleigh, NC
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
I did pick up a yoohoo (3L220) belt I can throw on today. I just need to know if I can ditch the air pump and at a later date ditch the ACV when I have block off plates to install.
#4
Rotary Enthusiast
Join Date: May 2007
Location: Canada
Posts: 770
Likes: 0
Received 0 Likes
on
0 Posts
Cant you just cut out your own block off plates out off some sheet metal? That would be cheaper, and faster. I also plan on removing my air pump, cause I have no cat!
#6
Full Member
Thread Starter
Join Date: Jan 2004
Location: Raleigh, NC
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Well done is done. I'm running ACV without the airpump.
The ACV and EGR are next.
I must say, the yoohoo belt is pretty sweet. I'm glad I didn't spend $50 on a dual alt pulley.
Anyone know of any cheap block plates? I know pineapple & Mtrix have em.
The ACV and EGR are next.
I must say, the yoohoo belt is pretty sweet. I'm glad I didn't spend $50 on a dual alt pulley.
Anyone know of any cheap block plates? I know pineapple & Mtrix have em.
#7
Senior Member
Join Date: Mar 2004
Location: Troy, NY
Posts: 319
Likes: 0
Received 0 Likes
on
0 Posts
http://www.2751engineering.com/2751parts.html
I got mine from here
I got mine from here
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
12abridgeport
1st Generation Specific (1979-1985)
2
08-17-15 06:28 PM