actuator rods
#2
Moderator
iTrader: (5)
For what? The 5th and 6th ports?
Take some PB blaster and sprtay the rods and actuators. Let it sit for a while and use a flat head screwdriver to work the rods in and out of the actuator. Lightly though, as to not bend the rods. If you do bend them, you'll have to pull the actuators off and rebuild them.
Take some PB blaster and sprtay the rods and actuators. Let it sit for a while and use a flat head screwdriver to work the rods in and out of the actuator. Lightly though, as to not bend the rods. If you do bend them, you'll have to pull the actuators off and rebuild them.
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM