I'm swapping over everything from one car into another and I do not want to put the ABS back. EVERYTHING from the donor car is going into the good body, entire harness, dash, ECU, motor, etc, etc. The body did not have ABS, so I have everything for the brake system I'm just a little worried that if I delete it and leave stuff unplugged I'll have a problem. Has anyone done this before...? Thanks.

 

Seriously? Did you attempt to search? Theres like 3 threads in the archive covering this, and many more in the general section. Its an extremely common mod.

 

No I didn't. I'm chin deep into swapping everything over.... Ill do it tonite when im in my jammies. Thanks tho.

 

The Master may need to differ from the original Abs I believe.(If you had Abs on the car and are changing to regular brakes)
but you can just take the sensors out of the wheel bearing assemblies and not worry about that aspect for sure...and if you can't get them out just cut the wires (Done..)!
EDIT: if the car had NO ABS then you are fine..ditch the unit and hook the system up as regular brakes..master to Proportional valve to Calipers.

 

Yea the ABS master was missing a port for the front drivers side. Without looking again to verify I believe it was bc the front went over in one line to the ABS system then split to the pass and back over to the drivers brake. Thanks Misters.

 

Just use a tee fitting or double banjo if you retain the original MC.