? about the pick-ups in the CAS
Thread Starter
Rick James
Joined: Sep 2002
Posts: 631
Likes: 0
From: Under The Hood In FL
? about the pick-ups in the CAS
I posted this on the other forum................
I had to pull them out to clean the case but after I put the pickups back into the CAS...........I don't know how far apart to set the pickups from the *spikes* (two big ones on the upper ,many smaller ones on the lower)
Can I use a feeler gauge to set the clearance? How far?
Here's a pic of what I'm talking abouthttp://www.teamfc3s.org/forum/showth...threadid=14480
I had to pull them out to clean the case but after I put the pickups back into the CAS...........I don't know how far apart to set the pickups from the *spikes* (two big ones on the upper ,many smaller ones on the lower)
Can I use a feeler gauge to set the clearance? How far?
Here's a pic of what I'm talking abouthttp://www.teamfc3s.org/forum/showth...threadid=14480
Seduced by the DARK SIDE
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
There is some leeway.
Just check that they clear maybe .005" when you push out the slack the rotor bearing.
I have seen similar reluctance heads give a usuable signal at .030".
Just check that they clear maybe .005" when you push out the slack the rotor bearing.
I have seen similar reluctance heads give a usuable signal at .030".
Last edited by SureShot; Jun 12, 2003 at 08:23 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Sammy Built
Haltech Forum
8
Sep 28, 2015 03:18 PM