I have read the great write up on here to do the swap and i have got almost all the way through it but i am having problems with the wiring and how it goes. I am using a 5spd donor from a 88 gtu. everything bolted up nice and i got two N350 ecu's with the 5spd in case i needed to switch them but the connectors are different. i think i need to disconnect my ec-at but im not sure what to do with the wires that come off the transmission. any help would be greatly appreciated?

 

Taken from Rotary Resurrection/Kevin Landers


General Procedures section

11)

wire reverse lights. Find the 2 red wires on the switch on your 5sp transmission.

If working with an 89-91 car, find the 6 wire plug near the starter, and the 3 wire plug near that. ON the 3 wire plug there are 2 pins together and one offset; run a wire from this pin to either of the red wires on the trans. On the 6 wire plug, locate the bottom row, center pin; run a wire from this pin to the other wire on the trans.