in2psi

I'm trying to fix this problem on my 89' TII. The 2nd owner of this car smashed or broke the connector to the BACV so he used some female speaker connectors to plug it back to the BACV I think he may have wired it wrong or put it the wrong connectors to the wrong wires cause as I did the usual check to the BACV cleaning it out and then ohm load test and 12volt power test to make sure it clicks. I found out, it works fine that's when I went to go and plug it in I realized that one of the female connectors he used actually has a wire that is not even connected so now I have three wires with two of them having female plugs! The first female plug has black w/ a pink stripe to it and then the second wire has black w/ a yellow stripe to it and then the third wire is colored green with a red dot on it but this wire is factory taped together w/ the black on yellow wire! My question is can any 89 TII owner tell me which wire goes to which male plug on the BACV if you were standing on the side of your passenger fender looking at your BACV in front of you with the front of the BACV closes to the shock tower, or can anyone tell me is there a place I can download the whole wiring diagram of this car by color code because I checked with the dealer and they don't even have books that old already alying around to help me out! I even looked on the one site from www.1300cc.com for a wiring diagram by color code and now dice! If anyone can help me out this would be great! I have been looking forward to getting this car running right since I got!
Thanks, Jon

Scott 89t2

hmmm.... there should be only 2 wires..

mine are black with white strip on the pass side. and black with green strip on the driver side. don't even match your colors??..

Scott 89t2

in2psi

Scott, is there any place you know off were I can down load a wiring diagram for this 89 TII that I have! If I can only find out which wire goes to the proper connection this might be the reason why this car doesn't work right!
If any else with an 89TII can step in and help me out that would be great!

Scott 89t2

there is nowhere online you can find it. I have the book though.

and it says wire closer to pass side is black with white strip, (same as mine) and closer to the driver side is blue with green stripe. maybe mine is blue not black. can't tell from that pic. but the green stripe is right.

I'm not sure where your black w/ a pink stripe, black w/ a yellow stripe, green with a red dot are comming from...

do your wires to everything else look right. and hooked up?

Scott 89t2

other stuff near by would be

the AWS which is black/white , brown/yellow

o2 sensor is green / yellow

port air solenoid. (ACV) black /white , blue
split air solenoid (ACV) black/white, blue/black

in2psi

Thanks Scott, I'll check it out but as far as I can see the black with pinkwire is taped into the factory harness I still have no clue to where it goes and what it should be plugged too! What's your email address so I can send you a pic because the wire I have looks green more than blue but I guess I can give it a try!