Hey this is my first encounter with a 13b rotory engine .. i did an engine and transmission swap from one body to another both are 89 rx7's only the body i put the engine in is a convertible and my old one was a coupe ... i marked mostly everything and am almost postitive that everything is hooked up correctly besides one hose that i can not remember where to hook up at .. it is circled in the attached photos ... it will start after several tries and pumping the gas rapidly .. but it wont idle on its own and when i rev it up to about 3000 rpms it sounds like abnormal sparking internally in the engine .. i did not disassemble the engine at all just swaped it out.. please help me on the location of where these hook up.. thank you in advanced

http://i143.photobucket.com/albums/r...0615091641.jpg

http://i143.photobucket.com/albums/r...615091641a.jpg

http://i143.photobucket.com/albums/r...0615091642.jpg

 

That's for the cold start. You don't need it. Are you sure the engine you picked up isn't blown?

It would be a direct swap, from vert to coupe. Do a compression check on it. Do you have the pressure sensor hooked up and afm connected? Also for not idling is your bac still there?