2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

89 GTUs a few problems. any help/advice?

Thread Tools
 
Search this Thread
 
Old Aug 12, 2005 | 05:17 AM
  #1  
xUnKnOwNx's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Aug 2005
Posts: 370
Likes: 0
From: San Francisco
89 GTUs a few problems. any help/advice?

i just purchased a 89 GTUS today. however the sholder seat belt dont work. its the kind where its auto, and it will lock you in place. the guy who sold it to me said i can get it fixed from the mazda dealer for free because theres a lifetime warranty for it or sumthing. is that true?

also the right turn signal lights dont work. i dont think its the bulbs because both the front and rear lights dont work. i tried the emergency lights and only the left one blinks. in addition to that, on the indicator (where the rpm meter is) i dont see the right indicator blink either. he told me its just some wiring....

o yea, he also gave me some 18" rims on the back. they are koing, 5 spokes. iono will this be bad for the car because the rear wheels are on 18s" but the front 2 wheels are on 16". if this is bad, i can just change it back to 16" ones.

on top of that, some smaller problems, the wind shield washer thing. the thing that sprays out the water to clean the wind shield. that little black thing. that one is missing. the one on the drivers side. i was told that i can find those in junk yards


any advice would help. thanks. my main concerns are the seatbelts and the right signal lights. i need to get it fixed ASAP.
Reply
Old Aug 12, 2005 | 09:23 AM
  #2  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
Originally Posted by xUnKnOwNx
i just purchased a 89 GTUS today. however the sholder seat belt dont work. its the kind where its auto, and it will lock you in place. the guy who sold it to me said i can get it fixed from the mazda dealer for free because theres a lifetime warranty for it or sumthing. is that true?
The S5 coupe seat belts are under a lifetime recall.

also the right turn signal lights dont work. i dont think its the bulbs because both the front and rear lights dont work. i tried the emergency lights and only the left one blinks. in addition to that, on the indicator (where the rpm meter is) i dont see the right indicator blink either. he told me its just some wiring....
You probably have a bad CPU flasher board (I sell rebuilt ones on my website) not a a wiring issue.

o yea, he also gave me some 18" rims on the back. they are koing, 5 spokes. iono will this be bad for the car because the rear wheels are on 18s" but the front 2 wheels are on 16". if this is bad, i can just change it back to 16" ones.
18 in wheels in the rear with 16 inch in the front will look pretty bad and very getto, and will considerably reduce performance of the car both in handling and accelleration. The 16 in and 16 in should be fine as long as they are not tyoo heavy.
Reply
Old Aug 12, 2005 | 12:22 PM
  #3  
xUnKnOwNx's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Aug 2005
Posts: 370
Likes: 0
From: San Francisco
hrmm.. so i should get the

"FCCBB01"?
Rebuilt Mazda/Imasen 67-5640-FB01 body computer circuit board. Turn signals.

Controls Turn signals, and Hazard lights only.

Instead of replacing the whole CPU, replace just the defective circuit board. For all FC Series RX-7 (86-92 only) and MX-3 All models.


as for the seatbelts. do i just drive it to any mazda dealership, and they will take care of everything for me?
Reply
Old Aug 12, 2005 | 12:34 PM
  #4  
Icemark's Avatar
Former Moderator. RIP Icemark.
 
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
The Mazda dealer will probably not want to fix them, and you will have to push the issue, but yes, they are required by Mazda North America to fix them under recall

As far as the CPU, if you are only having problems with the turn signals there is no sense spending the extra money for anything but the turn signal flasher board.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
scissorhands
New Member RX-7 Technical
5
Oct 8, 2015 01:17 PM
andernamen
1st Generation Specific (1979-1985)
4
Sep 27, 2015 03:32 AM
erevos
2nd Generation Specific (1986-1992)
4
Sep 15, 2015 09:19 AM
sinistersam
New Member RX-7 Technical
5
Sep 13, 2015 07:17 PM




All times are GMT -5. The time now is 06:04 AM.