88 starting problems
#1
Junior Member
Thread Starter
88 starting problems
i replaced my wires and plugs last night and since then i doesn't want to start. i can push start it, once its running it runs like a champ. no misfire at idle anymore. it takes usually a long time to crank over and i have to have it at wot.(note the choke plates are removed from previous owner and the intake and throttle body are ported and polished)
im new at the rx-7 game so any advice helps. thanks!
im new at the rx-7 game so any advice helps. thanks!
#5
Does it start at all when you crank? or does it just turn over, I had trouble with my FC also, it would not start, only push start. It turns out I had bad ground wiring, and the wires needed to be cleaned up, and also my starter terminals.
#6
Junior Member
Thread Starter
well it would make a faint click when i cranked it. and the gear on the solenoid had some play, which was kinda odd. all my wires were covered in a nasty substance. so everything got cleaned when i put the used starter in. and also now i don't have to even touch the throttle when i crank it. she starts right up. but that could of also been cured with my msd wires and new plugs.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM