87 tII wont return to idle (dies) after revving.
#1
Junior Member
Thread Starter
Join Date: Sep 2007
Location: richardson, tx
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
87 tII wont return to idle (dies) after revving.
i just rebuilt my 13b tII (3mm apex seals, large street port, race bearings). ive adjusted the timing and tps. but when ever i rev the engine and its supposed to return to idle it just dies unless i give it a little gas. the engine has 34 miles on it. will this problem go a way once i break in the engine further? or is it something else?
#2
Junior Member
Join Date: Nov 2007
Location: Ewa Beach, Hi
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
you may have to adjust your timing again. Should not cut out. My Evo would do this,and i adjusted the TPS again and timing. Do you have a dat logger? If so you may wana hook it up and check out your timing. And you did port your engine so your timing may still be a hair off.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM
acha3
2nd Generation Specific (1986-1992)
7
09-06-15 08:14 AM