8-10"hg @ 1000Rpm on rebuild, vac leak?
04-24-04, 09:50 PM
#1
Rotary Enthusiast
Thread Starter
Join Date: Dec 2002
Location: Darwin, NT, Australia
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
8-10"hg @ 1000Rpm on rebuild, vac leak?
howdy all,
Got my new rebuild idling pretty good now at 1,000rpm, but its only pulling between 8 and 10 inHg. Is this normal for a 0mile rebuilt engine with a largish street port with a fair bit of a overlap(for a street port)?
Or should it be pulling more than this even though its not got any k's on it yet?
I only ask because i've had to richen up the idle maps on the microtech a bit to get it idling i've looked for vac leak i dunno how many times and I can't find any, even when I spray water over suspect areas I can't find any.
So, should it be pulling more than 8-10inHg?
Got my new rebuild idling pretty good now at 1,000rpm, but its only pulling between 8 and 10 inHg. Is this normal for a 0mile rebuilt engine with a largish street port with a fair bit of a overlap(for a street port)?
Or should it be pulling more than this even though its not got any k's on it yet?
I only ask because i've had to richen up the idle maps on the microtech a bit to get it idling i've looked for vac leak i dunno how many times and I can't find any, even when I spray water over suspect areas I can't find any.
So, should it be pulling more than 8-10inHg?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM