alright i know theres been enough of these posts on here but this one is different.

so heres the deal my actuators aren't actuating

my actuators are working along with the sleeves
air is flowing through the lines to the selonoid without a problem and the air pump is working fine.
the selonoid itself is working i tested it and it is actuating.

heres the problem...when i tested the connector that connects to the selonoid there is no electrical signal what so ever no matter what rpm i rev the motor too. and i know that there is a signal sent at a curtain rpm to this selonoid. so am i looking at a burnt out wire somewhere along the line?

also. what sends the signal to the solonoid?....could that be burnt out?

does the signal get sent from reading where the rpm stick is on the tack?

thanks for the help

 

bump

 

the solenoid only gets the 12v if the engine is under load. cant just sit there in neutral revvin the engine.