2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

6000 rpm hesitation to one rotor

Thread Tools
 
Search this Thread
 
Old 12-16-11, 07:07 PM
  #1  
Tech Dweeb

Thread Starter
iTrader: (4)
 
Noxi's Avatar
 
Join Date: May 2008
Location: Elko, NV
Posts: 164
Likes: 0
Received 0 Likes on 0 Posts
6000 rpm hesitation to one rotor

Heres what happened I was on the freeway home when I put it into 3rd gear to pass some one and hit around 6k rpms and my car stuttered as if it hit fuel cut, (This this fuel cut issue has happened before but months ago.. and then went away)

After it hit the hesitation "Fuel cut" feeling the car lost all power and I realized I was only running on 1 rotor

I checked compression on my engine by pulling leading spark plugs and they all sound good

Heres the specs to my car
s4 N/a streetport (Rebuilt 3000miles ago)
Racing bead road race exhaust
rest is all stock

Using the search I read about people having similar problems Like injectors and TPS
But my car will not start at all now that I have parked it so I am assuming its not TPS which leads to possible bad injectors?
How would I test injectors?
Old 12-16-11, 07:46 PM
  #2  
Tech Dweeb

Thread Starter
iTrader: (4)
 
Noxi's Avatar
 
Join Date: May 2008
Location: Elko, NV
Posts: 164
Likes: 0
Received 0 Likes on 0 Posts
Fixed!!! End thread

I found the issue on my engine Harness wires leading to my Primary injectors

When I removed the rats nest months ago I left the loom where it was and it started to burn up the wires that were laying on the engine so i just cut and replaced them and tied the loom so that should never happen again
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
3rd Generation Specific (1993-2002)
13
01-09-18 11:19 AM
gxl90rx7
Haltech Forum
4
09-14-15 03:09 PM
rx7shirley
2nd Generation Specific (1986-1992)
6
09-02-15 02:11 PM



Quick Reply: 6000 rpm hesitation to one rotor



All times are GMT -5. The time now is 02:45 PM.