FC3SJin

Alright, so I searched for quite some time and i cant find out the exact information i need (if im missing it, im sorry). I have a 10th AE that I just did a motor swap on. The engine harness was in extremely bad shape, so I got another engine harness that was in great shape. now this harness came from an 87 TII. It has the plug for the resistor pack (and obviously, i dont have a resistor pack because i have an 88).

I had a small fire in my garage, and it got to the replacement harness I had, but it didnt damage the full harness, it only got to part of the injector wires (and 2 more plugs I believe), before i was able to put it out (lucky me).
The rest of the harness is totally fine, but the injector wires and clips are melted. I cut the wires to a point where they were not melted, and I dont know which wires go where. The wires im looking at are :
Green with a red line and red stripes,
green with a black line and red stripes,
another green with a black line and red stripes, but this wire is thinner
2 black wires with a white line and red stripes.
A brown wire with a red line and blue stripes,
and 2 brown wires with yellow lines and blue stripes(one thinner than the other).

I tried checking out a schematic, but of course i cant fully understand it (but im still trying). My questions are, out of the wires i listed, which are for the injectors, and , does it matter that the 87 harness is going into an 88? I have 2 sard 800cc injectors i want to install while im doing all this.

any help would be greatly appreciated. Thanks.