i need to see pics that anyone has of the cusco license plate relocation bracket.
what does it look like? is it worth it? installation? (hard to install, piece of cake, time, need to drill anything?)
thank you guys very much!

 

i thought all license plate relocaters lwork the same

 

you can buy a licesne plate relocater at orilys auto part... and stores like that.

 

anyone have a picture of the cusco one on their car?

 

ive never seen one, but i bet its over-priced

 

Just be creative and make your own. Its not hard and can be done for under five bucks.

 

here is a pic from the Cusco site of the license relocation bracket. I have installed a couple out here and didnt need to drill any holes. It is basically goof for moving the license plate away from blocking fresh air to the radiator.

http://www.cusco.co.jp/en/parts_prod...fset_stay.html

 

here is a pic of it on my car, it was cheap and took 2 bolts

 

thank you very much!

 

I have the cusco relocation as well

it bolts into the stock location..

only problem I had was the stock bolts were rusty and broke off when i was removing the frame.. doh

it's 2 pieces that bolt into each other.. then 1 side into the car.. 1 side into the plate...

my plate holes did not match the cusco frame tho.. so I have to re-drill another hole..

it is also angled down alot... as u can see.. so i've bent my plate to compensate..

dunno if ur local cops will give u a problem about that tho..

 

mine was the same way with the facotry bolts. and i havent been bothered by the cops for the angle its at.